* Sangean WR-2 Radio: Worst Clock Radio Ever, Good Tuner

Nothing is easy, but clock radios should not be this user-hostile.

In July 2007, I gushed about the Tivoli table radio (pictured below). Amazon’s reviews were great, so I bought one for Christmas for my wife. We had only one clock radio in our bedroom, a cheap GE model that I purchased when I was a freshman in college (23+ years ago). Whoever got up first had to reset the alarm for the other. And since my wife works the 7-3 shift at our local hospital, she is almost always the first one up.

So, two clock radios and we’re golden, right?

Wrong.

It turns out that I purchased the Tivoli Model One, which is indeed a nifty looking (and apparently sounding) radio. But it isn’t a clock radio at all. No clock. D’oh! So I researched the Tivoli Model Three, which appears to be a hacked version of the Tivoli Model One. The Tivoli Model one gets 4 stars on Amazon, the Tivoli Model Three only 3.5 stars. Why? It turns out that the Model Three runs the clock off of a single AA battery instead of AC power! Now it’s all fine and dandy to have a battery backup – you know, in case the power goes out – but to run the radio circuitry off of AC power and the clock circuitry off of DC power is just bad design. Why burn through batteries when you don’t have to? There are other flaws as well, but the Tivoli Model Three is no Tivoli Model One.

After concluding that the Tivoli Model Three was not for me due to the poor battery design, I searched for a substitute. Surely it would be easy to find a desktop clock radio that looks good and sounds good, right? Nothing is easy. I settled on the Sangean WR-2 (pictured above, top of page), which doesn’t look nearly as attractive as the Tivoli Model One, but which is supposed to have really good sound.

Guess what else the Sangean WR-2 has? The worst user interface for a clock radio ever! The owner’s manual is 24 pages long (24 pages!), of which three full pages (three full pages!) are instructions for how to use the clock radio. The instructions are bad, pathetic, and unreadable. The Sangean’s user-interface renders the clock feature of this supposed “clock radio” unusable. It takes seven steps to turn the alarm on, three steps to check if the alarm is on, and four steps to turn the alarm off!

Here are pages 10 and 11 (I am sparing you the “wake to buzzer alarm” page – who wants that?) from the owner’s manual (note my markups, an attempt to make sense of these horrible directions):

And here is the text of those pages with my pithy comments interspersed (in italics):

Wake to radio alarm

First of all, this should say “wake to RADIO.” Saying “radio alarm” is confusing.

When the radio alarm is selected, the radio will turn on and play the selected radio station. The radio alarm will sound for one hour unless turned off by pressing the On/Off button. Pressing the on/off button whilst the alarm is sounding will cancel the alarm for 24 hours.

The first sentence is promising. But the alarm only plays for an hour? How about playing until I turn it off? Say, for example, by moving an on/off SWITCH to “off”. Like on my 23-year-old GE clock radio. And if the alarm is canceled for 24 hours, does that mean it goes off the next day at the same time? Answer: yes. So beware of setting your alarm on Friday and planning on sleeping in on Saturday. Mr. Sangean is making the on-off switch on my ancient GE clock radio look better all the time.

1. When radio is off, press and release Display button will beep and flash alarm icon [alarm-clock icon] and previous alarm time. Note: when the radio is on, press and release Display button until display flashes alarm status.

OK, I’ve read this “sentence” a million times and have concluded that it is not, in fact, a sentence. And why the heck does it matter whether the radio is on or off? Sheesh!

2. During the flash, long press SET button until hour and minute digits also alarm model flash in the display.

Say what? Alarm model flash?

3. Press Hour and Minute button separately or rotary turning control to set required alarm time.

Calgon, take me away!

4. Press and release Select button to select radio alarm or radio alarm + buzzer alarm, display will flash [alarm-clock-speaker-something icon] or [bell-alarm-clock-speaker-something icon].

OK, to be clear, there are TWO possible alarm settings: radio or buzzer. The first setting has FOUR icons, the second setting has FIVE icons. It’s like a Gary Larson Far Side cartoon where the human is in an alien bar and is trying to figure out which bathroom is which based on the incomprehensible graphics on the doors. I can tell you this much. When you are tired, you don’t want to be taking MATH TESTS in order to set your clock radio.

5. Press Band button and rotary tuning knob to select required radio station. You can also select alarm station by recalling the preset stations pressing memory presets button.

Desire, required, whatever.

6. Press and release Set button to complete radio alarm set. Display will show radio alarm icon [alarm-clock-speaker-something icon].

OK, so step six and I’m done, right? Only SIX steps to set the alarm. Right?

7. The volume level will be same as last radio station listening to.

WTF! A seventh step that is basically a do-over step if you were previously using the radio for – oh I don’t know – a RADIO? Let’s say you listen to the radio on a loud setting while you’re taking a shower but you want it on a soft setting for waking you up. Guess what? You have to start over!

Monitor radio alarm station

Translation: here is a simple three-step process to figure out if your alarm is on or off.

Note: remote control unit is not applicable for this operation.

Who cares.

1. Ensure the radio is switched off.

Whatever.

2. Long press the M1 button, until display shows radio frequency. Hold down another 3 seconds, display will flash radio frequency, hold down another 3 seconds to cancel the set radio station.

Every time I tried to verify the radio station, I ended up holding down the stupid M1 button longer than pi seconds and ended up turning the alarm off.

3. Display will show “***”, when no radio station is set.

OK, so the rocket scientists who designed this “clock radio” had THREE characters to choose to indicate that the alarm is OFF, and they chose three asterisks. Brilliant. Here’s a suggestion. Spell the word “OFF”!

Snooze function

Snooze is not a function, it is a necessity.

1. Whilst an alarm is sounding, pressing any button (except the On/Off or Light button) will activate the snooze function. The radio or buzzer will be silenced for 5 minutes.

So any button EXCEPT the ones you hit when you’re tired, is that it? And a 5-minute snooze? Are you kidding me? Everybody knows that a snooze is supposed to be NINE minutes long. No more, no less. But not 5. I can’t fall asleep again in 5 minutes after 41 years of being trained to snooze for nine minutes!

2. The display will flash both the snooze symbol ZZZ and the alarm symbol. The snooze function can be repeated during the period that the alarms are active.

Here’s a design hint for you. Make a separate button called SNOOZE. Make it really big and hard to miss. Make it the ONLY button on the TOP of the radio. You know, so that sleepy people can snooze without having to take a MATH TEST!

Cancel alarm setting

Translation: here is a simple four-step process to turn the alarm off.

Cancel the alarm setting can be done both radio is on or off.

I hate you.

1. When radio is off, press and release Display button, display alarm icon will flash. (when radio is on, press Display button to alarm status)

You get an “F” for punctuation, grammar, and electronics design. Do not pass GO, do not collect $200, go directly to jail, where you can study electronics design.

2. Long press SET button until both alarm icon and time digits flash.

No, I won’t.

3. Press and release SELECT button until display flashes [alarm-clock icon].

Your icons suck.

4. Press SET button again to cancel alarm status. Display alarm icon will disappear after flashing a couple of seconds.

Seriously, Mr. Sangean, are your parents brother and sister? Your secret is safe with me. And as for how to use your “clock radio” feature, that’s apparently YOUR secret.

The Sangean WR-2’s poorly designed clock radio makes my 23-year-old GE – with it’s simple ON-OFF-RADIO-BUZZER switch – look downright revolutionary. We ended up keeping the Sangean WR-2 because it is a decent sounding radio. But the so-called “clock radio” feature is simply unusable.

Print Friendly, PDF & Email

18 Replies to “* Sangean WR-2 Radio: Worst Clock Radio Ever, Good Tuner”

  1. When it’s in use I have to touch the metal trim piece before I touch any on the buttons or volume control, or it blows it brains and none of the buttons will do anything. I have to unplug it, and wait several minutes, plug it in and start all over again. A real PITA.

  2. This is generally a good radio, however the most discouraging part is that the instructions are horrible and confusing. The main reason I would not recommend purchase of this radio is that the instruction are horrible and you cannot set the radio to go on at a set time and go off at a set time. I have an old radio that has this feature and can be easily set to go on at 6 AM and off at 11 PM on this Sangean WR-22 this is not possible.

  3. I have had a WR-2 for ten years. We used it as a clock radio, as we love to awake to Boston’s WCRB, classical music station. I struggled with the alarm settings for years, finally having to reset the the thing through the hole in the bottom of the box. This worked for a while, but now nothing will enable me to set the alarm any more….
    Has anyone tried to get one serviced?

  4. Thank you for an amazing giggle AND the help I actually needed! Against every possibility by the sounds of things, I accidentally turned the alarm on my WR2 ON !! I have had it for almost two years and have never used or even knew about the alarm feature… So when it suddenly set itself to go off at 130 AM and produced the most horrifying buzzing sound I had to figure out how to turn it off.

    Several downloaded manuals later (all WR2s are not created equal!) I was getting nowhere though I had at least found the right manual – but it really does read like the ramblings of a strange and potentially lunatic soul … Then I found your article and managed to turn the alarm off – Yay! Thank You!

  5. Very little about this radio’s functions and settings are intuitive. The buttons and labeling are tiny, really tiny. The clock gains about five minutes each month and the manual in a nightmare to decipher.
    The sound however is quite good and we can receive stations that the Bose, Tivoli and Boston Acoustics can not. I also think the cabinet is a handsome design.

  6. Sorry…..but Bose Wave Machines do not rule…..they are overpriced….radically…………don’t get me wrong, the sound is great, but the price tag is at least double what it ought to be. Additionally, on the newer model, the one lacking buttons, that little remote is a real pain in the butt.

Leave a Reply to Allan Corwin Cancel reply

Your email address will not be published. Required fields are marked *